Wall Mounted Towel Rail, 425 mm

Narrow walls get short bars, and this 425 mm rail is sized for exactly that job. One bath towel hangs flat on it, and the bar still clears a vanity or a shower screen on either side. The body is AISI 304 stainless steel, the grade used across interior washroom fittings, and it stands away from the wall far enough for a towel to dry without resting on the tile. A sensible default where the wall span will not take anything longer.

Key features

• 425 mm, chosen where a longer bar will not fit the wall
• Towel hangs clear of the tiling, so it dries properly
• Stainless steel throughout, no plated shell to wear through
• Brushed stainless steel, deep grey, Tinta or gold PVD
• Takes the same finish as the holder and hooks beside it

Specification and installation

Set the bar level on a structural wall or a proper backer, sealing around the fixings if it lies inside the wet zone, and check the wall is flat before tightening so the rail does not twist. Order the finish to match the fittings already chosen for the room and the bathroom reads as one scheme. The projection, fixing method and safe load are not recorded and should be confirmed before install.