Single wall-mounted roll holder in 316L stainless steel.

A toilet roll holder gets handled and wiped down more than almost any other bathroom fitting, which is why this one is machined from marine-grade AISI 316L rather than the standard 304 used on lower-traffic accessories. The molybdenum in 316L resists the chlorides in tap water and cleaning sprays that gradually dull a lesser grade. A single spindle carries the roll from a wall bracket, with a domed cap at the free end so the roll cannot slide off.

Key features

• Single 157 mm spindle projects clear of the wall-mounted bracket
• A domed end cap keeps the roll in place without a cover flap
• AISI 316L resists the chemical wipe-downs a washroom needs daily
• Four finishes match the ring and rail from the same range

Specification and installation

The bracket carries a 12 mm spindle that reaches 157 mm from the wall, finishing in a 24 mm domed cap that stops the roll sliding free; loading a fresh roll means lifting it over that cap rather than removing a cover. Fix the bracket to a stud or plugged masonry using the 24 mm sleeve common across the Volga range. Pair it with the ring or the vertical holder where two rolls are needed.