Vertical wall-mounted roll holder in 316L stainless steel

Specify this where the single wall-mounted roll holder will not work: a strip of wall too narrow for anything projecting sideways. The spindle here rises vertically off a small 316L stainless bracket instead of reaching out from the wall, so the whole fitting needs only the width of its own wall plate. The same marine-grade steel keeps that bracket from staining in a shower room's daily condensation, exactly as it does on the rest of the Volga range.

Key features

• Vertical spindle needs only its bracket's width, not a run of sideways wall
• Open top lets a fresh roll drop straight on without removing the fitting
• AISI 316L stays unmarked by daily steam and splashback
• Same four PVD finishes as the rest of the Volga bathroom range

Specification and installation

The wall bracket projects 67-84 mm and carries a 12 mm spindle rising 157 mm, open at the top so a fresh roll drops straight on rather than threading through a closed end. Fix it with the 24 mm sleeve common to the range, into a stud or plugged masonry beside the WC. Where the wall run is wide enough, choose the single wall-mounted holder instead for a lower profile.