200 mm Square Adjustable Rain Shower Head

The square head is the one that reads as a piece of architecture rather than a fitting: a 200 by 200 mm plate set flush to a tiled ceiling, its edges lining up with the tile grid, and only 4 mm deep so the plane of the shower stays flat. The face adjusts, the nozzles are soft, and the body is AISI 316L stainless steel, the molybdenum-bearing grade that keeps its surface in humid, chlorinated and hard water environments.

Key features

• Square plate aligns with tile lines instead of interrupting them
• 200 by 200 mm face, a compact overhead spray in a small bathroom
• Only 4 mm deep, so the ceiling plane is left undisturbed
• 316L stainless steel chosen for coastal and commercial installations

Specification and installation

Centre the plate on the shower zone and run the feed to it from a vertical or horizontal arm of the matching finish, then grout and seal the perimeter so the joint reads as part of the ceiling. Available in brushed stainless steel or polished stainless steel. Thread size and projection are not published for this record, so set the fixing out from the drawing.