Concealed Wall Mounted Basin Faucet 180mm Spout

In a tiled wall behind a basin, the tap you can see is only the end of the fitting: the mixer itself sits inside the wall, and what remains in the room is a spout and a pair of hot and cold controls. This faucet is that arrangement, carrying a 21mm spout 180mm long. The exposed parts are AISI 316L stainless steel, chosen for washrooms where daily disinfection and constant humidity would mark anything lighter.

Key features

• 21mm spout 180mm long, sized for a standard depth washbasin
• Hot and cold controls set at the wall, spout fed from the same body
• Only two fittings touch the tile, so the wall face wipes clean
• Five finishes let a specifier match other fittings in the room

Specification and installation

A concealed body is required and must be installed and tested before the wall is tiled or boarded over. Set the spout height so the stream lands in the bowl, not on the rim, and check the 180mm projection against the basin specified. Finishes run brushed stainless steel, polished stainless steel, deep grey, gold PVD and Tinta, so it can be ordered to continue a room scheme.